將磁鐵切成小塊


1

我從1000瓦揚聲器中救出了這個10磅的磁鐵。

我試圖用它製作更小的磁鐵。

Wikihow表示要么用錘子將其切碎,要么用鋼鋸對其進行鋸切。

我正在尋找實現這一目標的想法。

enter image description here

3

It is impossible to cut a speaker magnet with a hacksaw because the magnet material is harder than the hacksaw teeth.

You can break a magnet into smaller pieces by scribing the break lines onto the magnet surface with a single point diamond scribe and then flipping the magnet over and striking the backside of the magnet surface with a hammer and chisel, where the chisel edge is aligned with the direction of the scribe line on the opposite side.

But the best way to accurately separate a magnet into smaller pieces is with a diamond-wheel grinder.

Note that the most common magnet material used in big and cheap loudspeakers is barium ferrite. This is what your magnet is made of, which is not the strongest magnetic material available. Small rare earth magnets are on a per pound basis far stronger and can be bought cheaply in a variety of shapes.


2

These are typically "ferrites". Not metals but intermetallics. So they are not malleable /deformable like metal. Think of it as having physical properties like a ceramic- hard, brittle. It may be cuttable with an abrasive wheel but you may need a diamond wheel as would be used for ceramics,