在最終穀物上切出燕尾的最佳方法是什麼


1

我正在製作一個藥櫃,我想使用一個停止的,滑動的燕尾榫接縫,以便隱藏該接縫。我可以在a鉋機上用燕尾榫切割邊板上的滑動燕尾榫,但是在連接板的末端紋理上切割相應燕尾榫的最佳方法是什麼?我嘗試過製作一些夾具,但是它們似乎總是難以使用。

drawing of sliding dovetail joint

(請原諒這張可憐的畫。我對GIMP還不太滿意。)

0

I figured out a way to do it but it's still precarious.

I built a tall fence for my router table and then hand-held the piece against the fence and moved it across the dovetail bit. I got reasonably good dovetails on the ends of the pieces where I need them.

A better solution might have been to build a sled and mount it on my miter gauge. Then I could clamp the wood to the sled and guide it past the bit with the miter gauge.


1

I would just cut this with a handheld router and an edge guide. Stand the board on end and clamp it to your workbench so that the edge is flush with the bench top or clamp a thicker board to it so that your router doesn't tip back and forth.

As long as your edge guide has a microadjust it should be easy enough to dial in the fit. You might want to cut all the bottom sides first so that they're flush and then dial in the thickness.

I would caution you, though, that this looks like a pretty weak joint. At the "point" of the dado in the sides you're going to have very little material and the grain will be oriented so it will be easy to break off the edge of the board...