在同一塊木頭的兩邊對接


0

在規劃和設計櫥櫃時,我錯誤地假設在一塊木頭的同一側製作兩個對接J1和J2。在進行工作時,我意識到J1需要從下到上的螺釘,而J2需要從上到下的螺釘,如果我先做一個,就不可能再做另一個。我認為其中一個接頭需要使用小孔螺絲釘完成。所有零件都是3/4"硬木。還有更好的選擇嗎?我該如何挽救?

|(1)
|
|(J1)
==============(2)
|(J2)
|
|
|(3)

側視圖-

Side View

前視圖-

Front view

Here is a pencil sketch

1

I think a much more common approach would be to make the upper cabinet a stand-alone unit with its own bottom. Then, when you assemble the two units, you'd use short screws driven up through the top of the lower unit.

This would have a secondary benefit as well. As you currently envisage it, getting the doors right on the upper unit will be a very, very tricky (and probably frustrating) exercise in fitting. If the upper unit leans even a tiny bit forward, the doors are going to make contact with the top of the lower unit when they open - and with 15 inch doors that's not going to take much. Going to a separate upper unit would allow a face piece to fill in a small gap (say, 1/8 to 1/4) under the doors. This would give you a bit of clearance to allow the doors to swing freely.